10 AWG 37C Shielded Copper PE/PVC Insulation PVC Jacket Control Cable 600V

10 AWG 37C Shielded Copper PE/PVC Insulation PVC Jacket Control Cable 600V

Applications:

The 600 Volt control cables are suited for use in wet and dry areas, conduits, ducts, troughs, trays, direct burial, aerial supported by a messenger, and where superior electrical properties are desired. These cables are capable of operating continuously at the conductor temperature not in excess of 90°C for normal operation in wet and dry locations, 130°C for emergency overload, and 250°C for short circuit conditions.

Control Cable 600 Volt Copper Conductors, Polyethylene Polyvinyl Chloride (PE/PVC) Insulation Shielded Polyvinyl Chloride (PVC) Jacket, Control Cable Conductor Identification Method 1 Table 1. Silicone Free.

Also Known AS:

10 AWG 37C Shielded Control Cable, 10 AWG 37C Instrumentation Cable, Multi-Core Shielded Control Cable, 10 AWG 37C Shielded, Multi-Conductor Cable, Control & Signal Cable, Screened Control Cable, Industrial Control Cable, 10 AWG 37C Automation Cable.

Standards:

• ASTM B3 Standard Specification for Soft or Annealed Copper Wire
• ASTM B8 Concentric-Lay-Stranded Copper Conductors
• CSA CSA marking is available upon request
• ICEA S-58-679 Control Cable Conductor Identification Method 1 Table 1
• ICEA S-73-532 Standard for Control, Thermocouple Extension and Instrumentation Cables
• ICEA S-95-658 (NEMA WC70) Power Cables Rated 2000 Volts or Less for the Distribution of Electrical Energy
• IEEE 1202 FT4 Vertical Tray Flame Test (70,000 Btu/hr) and ICEA T-29-520 - (210,000 Btu/hr)
• VW-1 (Vertical-Wire) Flame Test

Construction:

Conductor:
 7 strands class B compressed bare copper per ASTM B3 and ASTM B8

Insulation:
Polyethylene (PE) 20 Mils thick and Polyvinyl Chloride (PVC) 10 Mils thick for all cable sizes

Filler:
Polypropylene filler on cables with 5 or less conductors

Binder:
Polyester flat thread binder tape applied for cables with more than 5 conductors

Shielding:
5 mils tape shield

Rip Chord:
Rip chord for ease of jacket removal

Overall Jacket:
Polyvinyl Chloride (PVC) Jacket

Specifications:

• Size: 10 AWG 
• Number of Conductors: 37
• Diameter Over Conductor (inch):   0.111
• Insulation Thickness (Mil): 30
• Jacket Thickness (Mil): 80
• Approx. OD (In): 1.355
• Copper Weight (Lbs/1000'Ft):   1198
• Approx. Weight (Lbs/1000'Ft):   1755
• DC Resistance Ω /1000ft: 1.040
• AC Resistance @ 90°C Ω /1000ft:  1.300 
• Min Bending Radius (In): 6.8
• Allowable Ampacity At 60°C (Amp): 12
• Allowable Ampacity At 75°C (Amp):  14
• Allowable Ampacity 90°C (Amp): 16